From Industrial-Craft-Wiki
Jump to navigation
Jump to search
|
|
| (42 intermediate revisions by 23 users not shown) |
| Line 1: |
Line 1: |
| The High Voltage Transformer is used to turn [[Current#Extreme Voltage|Extreme Voltage]] (EV) [[EU]] current into [[Current#High Voltage|High Voltage]] (HV) and back. This transformation is useful for carrying EU over extreme distances without significant losses.
| | #REDIRECT [[Transformer#HV-Transformer]] |
| | |
| All energy that comes into the Transformer through all sides except the output face will power it up. The HV current is then emitted through the output face. A redstone signal must be applied to the Transformer in order to make it emit EV current.
| |
| | |
| == Recipe ==
| |
| | |
| {{Grid/Crafting Table
| |
| |B1=Cable
| |
| |A2=Electronic Circuit|B2=MV Transformer|C2=Energy Crystal
| |
| |B3=Cable
| |
| | |
| |Output=HV Transformer
| |
| }}
| |
| | |
| == Usage ==
| |
| | |
| When using any Transformer, remember that the 3-dotted side means '''higher current''' and the 1-dotted side mean '''lower current'''. You can change the direction the 3-dotted side is facing by right-clicking a 1-dotted side with a [[Wrench]].
| |
| | |
| === Converting to HV: ===
| |
| | |
| In order to convert EV to HV, you must point the [[Cable|cable]] carrying EV from another HV Transformer to the 3-dotted side and then link a cable to one of the sides with a single dot. Then that cable will be carrying HV that you can link to an [[MFS Unit]] or an [[MV Transformer]].
| |
| | |
| === Converting to EV: ===
| |
| | |
| In order to convert HV to EV, point the cable carrying HV from an MFS Unit or an MV Transformer to one of the one-dotted sides and then link a cable that can carry EV to the 3-dotted side. '''Do not forget to apply redstone''' to the HV Transformer.
| |
| | |
| {{Navigation}}
| |
| | |
| [[Category:Wiring]]
| |
Latest revision as of 09:41, 10 December 2016
